nblocks:n-pro-00
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
nblocks:n-pro-00 [2022/01/13 05:57] engineer [Getting started] |
nblocks:n-pro-00 [2022/01/13 06:05] (current) engineer [Getting started] |
||
|---|---|---|---|
| Line 122: | Line 122: | ||
| The 10-pin JTAG connector available on board, is to program a target ARM-Cortex board (Not the n-PRO-00 LPC11U35 Microcontroller). \\ | The 10-pin JTAG connector available on board, is to program a target ARM-Cortex board (Not the n-PRO-00 LPC11U35 Microcontroller). \\ | ||
| \\ | \\ | ||
| - | <WRAP centeralign>{{:nblocks:n-pro-00-prog01.jpg|}} </WRAP> | + | <WRAP centeralign>{{:nblocks:n-pro-00-prog01.jpg?600|}} </WRAP> |
| \\ | \\ | ||
| - | To be able to use the n-PRO-00 as programming tool we first need to program it with one of the binaries below: | + | To be able to use the n-PRO-00 as programming tool we first need to program it with one of the binaries below:\\ |
| + | Once the CMSIS-DAP firmware is programmed to n-PRO-00 LPC11U35 Flash memory, it appears as a USB disk.\\ | ||
| + | Now we are ready to drag n drop the binary for the target board to the USB disk.\\ | ||
| ==LPC1768/LPC812== | ==LPC1768/LPC812== | ||
nblocks/n-pro-00.1642071437.txt.gz · Last modified: 2022/01/13 05:57 by engineer
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
