nblocks:n-pro-40
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
nblocks:n-pro-40 [2020/02/07 10:40] faizan [Table] |
nblocks:n-pro-40 [2020/06/02 12:33] (current) engineer |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| ===== Overview===== | ===== Overview===== | ||
| <poem> | <poem> | ||
| - | [[nblocks:n-PN LoRaWAN|n-PRO-40]] board is a low-cost and easy-to-use development kit for quick evaluation and to start some development with LoRaWAN protocol. It uses an ARM® 32-bit Cortex™-M and is totally compatible with n-Best ecosystem. It is based on Murata CMWX1ZZABZ LoRa module and also features STM32L082 microcontroller. The exclusive combination of an Arm® Cortex®-M0+ core and STM32 ultra-low-power features, makes the STM32L082 the best fit for applications operating on batteries or supplied by energy harvesting. It is the ideal solution for the users having no or little experience of networking to design Ultra Low-power IoT projects. | + | [[nblocks:n-PN LoRaWAN|n-PRO-40]] board is a low-cost and easy-to-use development kit for quick evaluation and to start some development with LoRaWAN protocol. It uses an ARM® 32-bit Cortex™-M and is totally compatible with n-Blocks ecosystem. It is based on Murata CMWX1ZZABZ LoRa module and also features STM32L082 microcontroller. The exclusive combination of an Arm® Cortex®-M0+ core and STM32 ultra-low-power features, makes the STM32L082 the best fit for applications operating on batteries or supplied by energy harvesting. It is the ideal solution for the users having no or little experience of networking to design Ultra Low-power IoT projects. |
| Communication with the module can be achieved via UART, SPI, or I2C peripheral interfaces. GPIOs provide plenty of flexibility for connecting sensors, switches and status LEDs, and the module is powered from a 1.6 to 3.6 VDC supply. | Communication with the module can be achieved via UART, SPI, or I2C peripheral interfaces. GPIOs provide plenty of flexibility for connecting sensors, switches and status LEDs, and the module is powered from a 1.6 to 3.6 VDC supply. | ||
| Line 106: | Line 106: | ||
| <WRAP centeralign>{{nblocks:n-pro-40-v22.jpg?300|}}</WRAP> | <WRAP centeralign>{{nblocks:n-pro-40-v22.jpg?300|}}</WRAP> | ||
| \\ | \\ | ||
| - | ** to be updated** | + | <WRAP centeralign>{{:nblocks:n-pro-40-nbusa.jpg|}}</WRAP> |
| + | \\ | ||
| + | <WRAP centeralign>{{:nblocks:n-pro-40-nbusb.jpg|}} </WRAP> | ||
| + | \\ | ||
| + | <WRAP centeralign>{{:nblocks:n-pro-40-nbusc.jpg|}}</WRAP> | ||
| + | \\ | ||
| + | <WRAP centeralign>{{:nblocks:n-pro-40-nbusd.jpg|}}</WRAP> | ||
nblocks/n-pro-40.1581090049.txt.gz · Last modified: 2020/02/07 10:40 by faizan
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
