nblocks:n-pro-mbsen
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
nblocks:n-pro-mbsen [2020/02/17 16:13] engineer created |
nblocks:n-pro-mbsen [2020/02/17 16:23] (current) engineer |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ======n-PRO-MBSEN====== | ======n-PRO-MBSEN====== | ||
| + | Wall-mount Sensor Node | ||
| ~~CLOSETOC~~ | ~~CLOSETOC~~ | ||
| <WRAP no_pdf > | <WRAP no_pdf > | ||
| Line 6: | Line 7: | ||
| <WRAP right 220px nblock round :en> | <WRAP right 220px nblock round :en> | ||
| <WRAP centeralign>//**n-PRO-MBSEN**// </WRAP> | <WRAP centeralign>//**n-PRO-MBSEN**// </WRAP> | ||
| - | {{:nblocks:N-PRO-MBSEN-02.JPG}} | + | {{:nblocks:N-PRO-MBSEN-03.JPG}} |
| <WRAP centeralign> | <WRAP centeralign> | ||
| n-PRO-MBSEN</WRAP> | n-PRO-MBSEN</WRAP> | ||
| Line 17: | Line 18: | ||
| </WRAP> | </WRAP> | ||
| - | [[nblocks:n-PRO-BSEN|n-PRO-MBSEN]] A 120 pins n-PRO n-Block can be used with this 12 pin adapter-breakout, for low pin-count applications, using a perforated board and simple soldering/wiring | + | [[nblocks:n-PRO-BSEN|n-PRO-MBSEN]] Wireless Sensor Customized Motherboard |
| - | <WRAP centeralign>{{:nblocks:N-PRO-12-PIN-01.JPG?300|}}</WRAP> | + | |
| + | <WRAP centeralign>{{:nblocks:N-PRO-MBSEN-01.JPG?300|}}</WRAP> | ||
| ===== Overview===== | ===== Overview===== | ||
| <poem> | <poem> | ||
| [[nblocks:n-PRO-MBSEN|n-PRO-MBSEN]] board | [[nblocks:n-PRO-MBSEN|n-PRO-MBSEN]] board | ||
nblocks/n-pro-mbsen.1581973995.txt.gz · Last modified: 2020/02/17 16:13 by engineer
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
