This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
nblocks:n-pro-sen1 [2020/01/23 10:19] engineer ↷ Links adapted because of a move operation |
nblocks:n-pro-sen1 [2020/02/12 08:24] (current) faizan |
||
---|---|---|---|
Line 7: | Line 7: | ||
<WRAP centeralign> | <WRAP centeralign> | ||
n-PRO-s1</WRAP> | n-PRO-s1</WRAP> | ||
- | | License | GPL 2.0 | | + | | License | GPL 2.0 | |
- | | Status | Tested | | + | | Status | Tested | |
- | | Buy at: | | | + | | Buy at: | | |
- | | Categories | | | + | | Categories | | |
- | | Hardware repo | [[https://bitbucket.org/nimbus_it/n-pro-s1|Bitbucket]] | | + | | Hardware repo | [[https://bitbucket.org/nimbus_it/pcba-n-pro-sen1|Bitbucket]] | |
- | | Firmware repo | [[https://bitbucket.org/nimbus_it/n-pro-s1|Bitbucket]] | | + | | Firmware repo | | |
</WRAP> | </WRAP> | ||
Line 90: | Line 90: | ||
\\ | \\ | ||
- | =====Board Pinout Top side===== | + | =====Board Pinout===== |
n-PRO-3DP is a **PERIPHERAL** board with four Hirose DF30-series 60-pin low profile connectors at top side, following the [[nblocks:nproformfactor|n-Blocks PRO form factor]].\\ | n-PRO-3DP is a **PERIPHERAL** board with four Hirose DF30-series 60-pin low profile connectors at top side, following the [[nblocks:nproformfactor|n-Blocks PRO form factor]].\\ | ||
Line 97: | Line 97: | ||
- | **NBUS1** | ||
- | <csv> | ||
- | Pin No.,Pin Name,Description | ||
- | 2,GND, | ||
- | 6,SDA, | ||
- | 7,SCL, | ||
- | 24,IN1, | ||
- | 25,INT2, | ||
- | 26,INT3, | ||
- | 29,GND, | ||
- | 30,3.3V, | ||
- | 31,3.3V, | ||
- | 32,GND, | ||
- | 59,GND, | ||
- | |||
- | </csv> | ||
- | |||
- | **NBUS2** | ||
- | <csv> | ||
- | Pin No.,Pin Name,Description | ||
- | 2,GND, | ||
- | 29,GND, | ||
- | 30,3.3V, | ||
- | 31,3.3V, | ||
- | 32,GND, | ||
- | 59,GND, | ||
- | </csv> | ||
- | |||
- | |||
- | \\ | ||
- | \\ | ||