nblocks:n-pro_concept
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
nblocks:n-pro_concept [2019/06/26 12:21] engineer created |
nblocks:n-pro_concept [2020/01/03 10:53] (current) faizan |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| =====n-PRO concept===== | =====n-PRO concept===== | ||
| + | ====Standard series pros==== | ||
| + | * The 'standard' nBlocks 33x43mm form factor can support | ||
| + | * Both simple and complex use cases | ||
| + | * Microprocessors from Low pin count 32 pins, to higher like 140 QFP or even higher BGA | ||
| + | |||
| + | ====Standard series cons==== | ||
| * Supporting professional development need larger pin count than 24 pins | * Supporting professional development need larger pin count than 24 pins | ||
| - | * The 2.54 pitch can't support modular development | + | * The two 12pin 2.54 pitch Connectors can't support modular or Scalable development |
| - | * Good looking is important, a mesh of cables and bad connections is not attractive | + | * Any not trivial use case can end-up to a mesh of cables and bad connections |
| - | * The 'standard' nBlocks dimensions can support | + | * The missing link was a good quality dense and low profile connector |
| - | * both simple and complex use cases | + | |
| - | * Microprocessors from Low pin count 32 pins to higher like 140 QFP or even higher BGA can | + | ====n-PRO==== |
| + | * Same board dimensions and mounting holes as the standard series | ||
| + | * 240 pins connectivity spread in Four Hirose DF30-series 60-pin low profile connectors | ||
| + | * Has backwards form factor compatibility | ||
| + | * Scalable integration in simple way | ||
| + | * Prototyping is Fast, Modular No cables, looks good | ||
| + | * Mirror connectors: To connect additional fucntionality like RF, Sensors etc.All the motherboards have these connectors. | ||
| + | |||
| + | ====Host and Peripheral concept==== | ||
| + | * CPU boards are HOST | ||
| + | * Sensor boards are peripheral | ||
| + | * DAP programming / mbed-enable boards are peripheral | ||
| + | * Development boards are Peripheral | ||
| + | * Application boards are Peripheral | ||
| + | |||
nblocks/n-pro_concept.1561566096.txt.gz · Last modified: 2019/06/26 17:21 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
