nblocks:n-pro_concept
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
nblocks:n-pro_concept [2019/08/26 02:47] engineer [Host and Peripheral concept] |
nblocks:n-pro_concept [2020/01/03 10:53] (current) faizan |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| =====n-PRO concept===== | =====n-PRO concept===== | ||
| ====Standard series pros==== | ====Standard series pros==== | ||
| - | * The 'standard' nBlocks 'real estate' can support | + | * The 'standard' nBlocks 33x43mm form factor can support |
| * Both simple and complex use cases | * Both simple and complex use cases | ||
| * Microprocessors from Low pin count 32 pins, to higher like 140 QFP or even higher BGA | * Microprocessors from Low pin count 32 pins, to higher like 140 QFP or even higher BGA | ||
| Line 13: | Line 13: | ||
| ====n-PRO==== | ====n-PRO==== | ||
| * Same board dimensions and mounting holes as the standard series | * Same board dimensions and mounting holes as the standard series | ||
| - | * 240 pins connectivity spread in 4 MOLEX XXXX connectors | + | * 240 pins connectivity spread in Four Hirose DF30-series 60-pin low profile connectors |
| * Has backwards form factor compatibility | * Has backwards form factor compatibility | ||
| * Scalable integration in simple way | * Scalable integration in simple way | ||
| Line 24: | Line 24: | ||
| * DAP programming / mbed-enable boards are peripheral | * DAP programming / mbed-enable boards are peripheral | ||
| * Development boards are Peripheral | * Development boards are Peripheral | ||
| + | * Application boards are Peripheral | ||
nblocks/n-pro_concept.1566802064.txt.gz ยท Last modified: 2019/08/26 02:47 by engineer
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
